Dec 19, 2025, 3:34:07 AM
|
Sweet Home 3D Forum » List all forums » » Forum: Features use and tips » » » Thread: X-axis and Electric Outlet... |
|
| Print at Dec 19, 2025, 3:34:07 AM | View all posts in this thread on one page |
| Posted by oren32 at Aug 21, 2013, 11:56:51 AM |
|
X-axis and Electric Outlet... Hi, I inserted an electric outlet into my drawing. I know it starts 60cm from the "East" wall. So if the end point of the X-axis is 700, then it should be 640 - and that is what I put there. Now, if I make the width of it 20 cm (There are actually few electric outlets there in my own room, but I want to use only long one in the drawing), then it stretches to both sides - I can see it in the 3D view. But the X-axis of it stays 640. So actually, the X-axis represent the location of the middle of electric outlet and not the most "east" location of it (Its beginning). My question: Is there a way to make the X-axis represent the most "east" location of the electric outlet, so no matter what width I decide to make it, I can easily make sure it will start X-cm (60 in my case) from the most "east" wall? Thanks Oren |
|
|
Current timezone is GMT Dec 19, 2025, 3:34:07 AM |