Print this post - Re: How to do a vaulted and flat ceiling of a single wall

Hello and thank you for the reply.
I created a sample design to illustrate my question.
http://imgur.com/a/x9gVK
In this example, two rooms that share a wall in the center. Room A I would like to have a flat ceiling. Room B a vaulted ceiling. Room A all walls are flat except for the one in the center. In the Virtual Visit, it shows a gap where the ceiling is being raised up rather than staying flat. Is there a way to force the ceiling to stay flat? Room B looks correct and has the vault.
I am sure there is way but so far I cannot find out how.
Thanks again.Chris

I think that there is a mistake. [:D]
You speak about ceiling and it's perhaps a roof.

1. To have an vaulted ceiling you must use an arch (with same heights),
or semi-arch with different heights.

2. For an inclinated ceiling (it's not the same thing), you must create your object (from a exported 'box' for example)
or put an inclinated roof which will give an inclinated ceiling...

Look at my given example below.

I hope that I have understood well your ask.

Regards.