Once again, I've made a couple of changes. This time just a couple of small ones.

https://www.mediafire.com/file/zqqhn290 ... .sh3d/file

The windows in the front were bothering me being two different sizes, and I wasn't all that happy with the half round ones, so I found a window: https://3dwarehouse.sketchup.com/model/ ... ow-3-angle

I used that along with the fixed window in the basic library. I couldn't actually get both sides the same width because that front section isn't centered. Hopefully the difference isn't too noticeable.

I also added the triangle gable vent in the attic in place of the half round window. Finally, I switched the placement of the window and the towel rack in the en suite bathroom.











And now that I look at these pictures... I think I might change the front door... seeing as there are no longer any half round windows... [:D]