Hi everyone, I'm not native English, so be patient with my short vocabulary.

I was doing a multi-storey house, with a wall height of 2.7m and a floor growth of 0.12m, so, if I want a wall for two floors, 2.7+2.7+0.12= 5.52 total height.
Up to here, is everything correct, but when I try to make a wall for three floors, I can't see the wall on the last floor in the 2d view.

My question is, is this maybe caused because of the programm doesn't support more than two floor's walls? Or is it a config error of my programm?

Some help would be apreciated. Thanks.