I need to draw on occasions slope floors, ramps and sloped interior ceilings.
How can I do that In a simple way? I was looking i.e. for the floor function to have a sizable thickness function.
For example a function were I have a rectangular floor and I can enter that on point A is 0, point B also 0 but on point C and D is 4 inches higher. Thus depending on the length between A to C and B to D accordingly the slope is.
This would be typical for a garage floor which slopes down towards the garage door.
Ceilings are a similar situation. Let's say a ceiling across the room inclines from the standard room height by the window towards the other side by 1 m or feet whatever you're measure in.