shadowmatrix0101
Newbie
Joined: Dec 20, 2014
Post Count: 1
Status:
Offline
|
|
|
Re: Display dimensions in inches only?
|
It's been three years, nearly four now, since this subject matter was posted and I'm curious if any changes have been made since then to add the ability to change the ruler from feet to inches. While some previous posters may have been slightly rude in their answers, it is an extremely important feature for those of us in the U.S. who don't use metric or who have a project that requires precise inch measurements rather than feet. I'm currently redesigning a small (7'x7') laundry room where eight inches here, ten and a half inches there, another two inches over there for wiggle room makes a big difference in whether I can put a sink between a washer and dryer or if I have enough room to place a whole new set of cabinets.
Please tell me the designers of this software have taken this into account in the past four years. Otherwise I'll have to look elsewhere. Thank you.
|
[Dec 20, 2014, 6:46:30 AM]
|
|
[Link]
|
|
