Doors not punching holes

[Lynn22]

Hi everybody, I'm new to the forum but not new to Sweet Home which I discovered several years ago and may I congratulate the developer since the program has really 'matured' over the years.

Getting back into building interiors I've ran into a snag. I downloaded the models listed below but when I place them in my building - with magnetism turned on - they will only snap to the outside (inner or outer) of a wall. When I turn magnetism off then I can place them in the wall but they don't create the 'hole' they should fit in.

Is there any setting that I am missing to make this work ?

Many thanks for any help I can get



Sliding French doors http://www.sweethome3d.com/models/contr ... hDoors.zip
Darker front door http://www.sweethome3d.com/models/contr ... orDark.zip
Door http://www.sweethome3d.com/models/contr ... /door1.zip
Exterior door http://www.sweethome3d.com/models/kator ... oor-07.zip

[beber_mal]

have you check the option "door or window" in the furniture import wizard?

[Lynn22]

Thank you very much beber_mal that was the setting that I missed.
All is working fine now