Hello,
this sounds like a rather common problem with any 3d software. Imho this happpens if the walls are not equal which causes the ceiling being forced to "bend" - which is impossible. you have to make sure that e.g. the walls facing each other are the same. try to imagine the ceiling in real life. you cannot "bend" a rectangle or a triangle in software, even if you can imagine it because in real life there is just a funny looking ceiling.
macfrog
Sloping ceiling problem
This topic has been viewed 8847 times and has 10 replies
Who is online
Users browsing this forum: No registered users and 1 guest