Small printing issue with dimensions, but can work around with svg export

[SourAway]

Hello Forum,
and thank you Emmanuel Puybaret for the great software you coded.

I wanted to report a small issue when printing dimensions. The stop/end lines (don't know how to describe better) are a bit too thick in the print while they are displayed nicely in the plan.

This applies also to the Print to PDF function.

But the Plan SVG-Export worked wonderful with Inkscape. I just had to rescale/set the Objects pixel = cm and divide that by the scale for printing.

So there's no hurry, I just wanted to mention it.


Another proposal would be an option to limit the print area to the current selection. (This was greyed out in the windows print dialogue)

[Puybaret]

The line thickness at print time was already reduced in version 4.0. Did you try with that version or an older one?

[SourAway]

Hi Puybaret,
thank you for the fast answer. (I am obviously slower

I am using version 4.1 in Windows 8/64.

Here's an example (with PDF, scale 1:100):


Hopefully you notice that the horizontal lines of i.e. measure "307" are thicker than the vertical line.