Is it possible to create curved wall?

[Hymer]

I should like to draw a wall on a sector base. The wall is vertically straight, as usual, but the base of it will be curved. Is there any solution?

[okh]

The wall tool-tip describes curved walls: Use CTRL (ALT on a Mac) when clicking end-point of wall, or enter the Arc extent in positive or negative degrees in wall properties later. To get a room to follow the curve, you need to auto-create: double-click with room tool within the room (must be closed). For windows and doors, some additional effort may be required, see thread 4840 with links to some possible solutions. ok

[Hymer]

Thank you, okh. Sweethome is a wonderful program.