can't position/place the end of a wall (straight or curved) where I want

[bbxrider]

I'm using very thin walls to create curved 'lines' on a drawing to trace electrical circuits from point to point, sometimes it works okay, but sometimes when trying to place the end of the wall with the [+] tool to position it, it won't let me put it to the point I want, when I get close it jumps away, up, down, sideways

[bbxrider]

ok just figured out, in the modify walls I can specify the x,y start and end points to position precisely, takes a little bit to see how, where, the x,y are positioned, but can just experiment to see if going in the right direction

[Mike53]

If you hold down the alt key when positioning walls or any object it cancels the magnetism that could be affecting your ability to position wall