Setting for world elevation

This topic has been viewed 4338 times and has 3 replies
Thread status: Active
Features you would like to see [img]http://www.sweethome3d.com/images/flags/en_small.gif[/img]
Post Reply New Topic
TinkyWinky
Posts: 10
Joined: Wed Aug 31, 2016 5:28 pm

Setting for world elevation

Post by TinkyWinky »

I am constructing house and environment. For my mental stability, the reference elevation is 0 := FFL (finished floor level). This means that that the garden's elevation is below 0.

The rest of the world is at height 0 which does not look so well. My garden is certainly not a pit digged into the groud as the air view suggests.

What would help here is a setting for the world's elevation. If set to -90, it would be at about my garden's height.
User avatar
UbuntuBirdy
Posts: 421
Joined: Thu Aug 31, 2017 10:31 pm
Country: Switzerland
Contact:

Re: Setting for world elevation

Post by UbuntuBirdy »

Oh, this would be very cool! I would love to set the elevation of Thun from 568m to 3m and go directly from my door to the beach within a few steps! [B-)]

I can hardly believe that your mental stability is that unstable that you can not set your reference level to 90.
Pascal

SH3D 6.6 / Ubuntu 22.04 (Mainline-Kernel) / Radeon RX580 / Ryzen 7 5800x
TinkyWinky
Posts: 10
Joined: Wed Aug 31, 2016 5:28 pm

Re: Setting for world elevation

Post by TinkyWinky »

Hey, the beach is 200km horizontally but only 34m vertically away for me, so this wouldn't solve the issue. [;)]

To explain the motivation better:

My project has (currently) about 40 levels. I imagined it would be easier to calculate offsets between several coordinate systems:
  • the bounder's plan uses normal height null as reference;
  • the architect's plan uses FFL as reference which is 34.8m above NHN;
  • the brick mason's notes use the lower edge of the base plate as reference which is 42cm below FFL;
  • I use the moisture barrier as reference of height which is 16.5mm below FFL since it is visible from the outside when I plan the modeling of the garden's surface;
  • when controlling the surface elevation, I use moisture barrier plus 50cm since my surveyor's level device is approx 10cm high and needs a tripod;
  • upper floor uses FFL plus 2,91m, attic adds some more height.

I know, it's just addition and subtraction in the range of -100 to +800. Not that difficult, especially for a computer engineer, isn't it?

However, oversight or miscalculation is difficult to correct when using armoured concrete. A good rule to avoid oversight is to keep it as simple as possible which means to translate all systems to _one_ coordinate system. I would prefer FFL.

Which leads to the world simply being 1m too high. [:)]
User avatar
UbuntuBirdy
Posts: 421
Joined: Thu Aug 31, 2017 10:31 pm
Country: Switzerland
Contact:

Re: Setting for world elevation

Post by UbuntuBirdy »

Ok, now I totally understand your wish!
Pascal

SH3D 6.6 / Ubuntu 22.04 (Mainline-Kernel) / Radeon RX580 / Ryzen 7 5800x
Post Reply New Topic

Who is online

Users browsing this forum: No registered users and 2 guests