Help with 2d config

[edermg05]

Hi everyone, I'm not native English, so be patient with my short vocabulary.

I was doing a multi-storey house, with a wall height of 2.7m and a floor growth of 0.12m, so, if I want a wall for two floors, 2.7+2.7+0.12= 5.52 total height.
Up to here, is everything correct, but when I try to make a wall for three floors, I can't see the wall on the last floor in the 2d view.

My question is, is this maybe caused because of the programm doesn't support more than two floor's walls? Or is it a config error of my programm?

Some help would be apreciated. Thanks.

[VeroniQ]

Hi edermg05,
Maybe this tip will help you?

[edermg05]

I think it is not exactly was I was wondering to know, but anyway, I have solved my problem, I just decided to stablish the height of the wall with the height of 1 floor, and just copying and pasting it for all the floors above it. Even though, thank you for your help.